hikvision firmware/固件 upgrade WI for IP camera

hikvision firmware/固件 upgrade WI for IP camera

 

Firmware download page:

http://www1.hikvision.com/cn/download_606.html

 

 

From: https://us.hikvision.com/en/support-resources/cybersecurity-center/updating-firmware

To upgrade the firmware of a Hikvision IP camera, please follow the steps below:

1. Locate the appropriate firmware by clicking this link
2. Click on the firmware, then click download.
3. Agree to the license terms and conditions when prompted.
4. Locate the downloaded firmware file (this typically will be in the default download folder, unless prompted for a download location, then choose Desktop) and extract it by right-clicking on the file and selecting extract all or unzip. When prompted for an extract location, choose Desktop to extract the final file to. A file labeled DIGICAP will appear on the desktop.
5. After the file is extracted, log into the camera using Internet Explorer or Firefox web browsers. If prompted to install the plugin (or to allow the plugin to run), follow the prompt to proceed with the upgrade procedure.
6. Log into the camera using the administrator username and password, then go to the Configuration tab. In this tab, go to Basic Configuration then System, and then click on the Maintenance tab.
7. On the bottom of the page under Remote Upgrade, press the Browse button to locate and choose the firmware file, which was previously saved on the Desktop. After selecting the file, click Open, then click Upgrade.
8. The camera will display a prompt that a reboot is necessary to complete the upgrade. Click OK. The camera will reboot when the firmware is successfully upgraded.